OFFICIAL OPENING

_{Save the date: On November 19, 2025, we will celebrate the}_{official reopening of FabLab Chemnitz}_!

_{Note regarding the offer/restriction: We have been offering the}_{weekly open workshop}_{from 4 p.m. to 8 p.m. again for a while now. However, we are still working on a few key areas until the opening in order to restore the original workshop offering from Philippstraße and are struggling with various infrastructure problems in the Stadtwirtschaft.}

trikarus

By Mario Voigt, 27 September, 2021

Printing with fine layers and ruptured line

The last two days of public Trikarus shows generated new insights again. At 04.09. i finished the print from august and also started to print a new soap car wheel body with finer layer quality (0.5 mm instead 1mm). I did this because the last wheel body broke again and i think the layer bonding was not good enough (as one factor).